Opek swr 3 инструкция русский

opek swr 3 инструкция русский
One of the most common causes of high SWR readings is incorrectly connecting your SWR meter to your radio and antenna. The easiest way to understand the concept is to think of it in terms of water flow. That is, there will be at least one switch with the marking Forward (FWD) in one position and Reference (REF or SWR) in the other.


All measurements should be taken with antenna tip on, unless you do not plan to use the tip in normal use. THE SET UP If already connected, disconnect the coaxial cable from the radio. Ground plane deficiencies can also be compensated for by using dual (co-phased) antennas or special no-ground-plane antenna kits. Поробовал и настроил, вроде и не сложно, но не записал. Разъёмы N — самое то, что надо. В виду постоянных проблем с элементами ААА, заменил последние на один LiIon аккумулятор, благо внутри есть разъём. Оценки: 5 / 5 / 4 / 5 / 4 / 5 Купил у знакомого 8 месяцев назад, ему не понравился по точности, (он себе БИРД-43 привёз). Померил им мой ICOM IC-7000 (не крученный, доверяю) с хорошей калиброванной нагрузкой, врёт на 20-25%. Открыл 2 подстроечных резистора и 2-а коденсатора.

Сейчас этот прибор не купить в 409shop, поэтому брал здесь:. The meter is now showing your SWR on channel one. Now, switch your radio to the middle channel (19 on CB). Place the meter switch in the Forward (FWD) position, depress the microphone switch and adjust the meter to place the needle on the Set position of the meter face. Few things can get under your skin as much as a stubborn SWR issue that you just can’t seem to pin down. If you’ve followed all the troubleshooting steps so far and are still having problems, sadly we probably won’t be able to offer any further guidance.

Похожие записи: